Section Text
(a) Types of requirements
The Commission may promulgate consumer product safety standards in accordance with the provisions of section 2058 of this title. A consumer product safety standard shall consist of one or more of any of the following types of requirements:
(1) Requirements expressed in terms of performance requirements.
(2) Requirements that a consumer product be marked with or accompanied by clear and adequate warnings or instructions, or requirements respecting the form of warnings or instructions.
Any requirement of such a standard shall be reasonably necessary to prevent or reduce an unreasonable risk of injury associated with such product.
(b) Reliance of Commission upon voluntary standards
(1) The Commission shall rely upon voluntary consumer product safety standards rather than promulgate a consumer product safety standard prescribing requirements described in subsection (a) whenever compliance with such voluntary standards would eliminate or adequately reduce the risk of injury addressed and it is likely that there will be substantial compliance with such voluntary standards.
(2) The Commission shall devise procedures to monitor compliance with any voluntary standards—
(A) upon which the Commission has relied under paragraph (1);
(B) which were developed with the participation of the Commission; or
(C) whose development the Commission has monitored.
(c) Contribution of Commission to development cost
If any person participates with the Commission in the development of a consumer product safety standard, the Commission may agree to contribute to the person’s cost with respect to such participation, in any case in which the Commission determines that such contribution is likely to result in a more satisfactory standard than would be developed without such contribution, and that the person is financially responsible. Regulations of the Commission shall set forth the items of cost in which it may participate, and shall exclude any contribution to the acquisition of land or buildings. Payments under agreements entered into under this subsection may be made without regard to section 3324(a) and (b) of title 31.
Editorial Notes
CODIFICATION In subsec. (c), "section 3324(a) and (b) of title 31" substituted for "section 3648 of the Revised Statutes of the United States (31 U.S.C. 529)" on authority of Pub. L. 97–258, §4(b), Sept. 13, 1982, 96 Stat. 1067, the first section of which enacted Title 31, Money and Finance.AMENDMENTS 1990—Subsec. (b). Pub. L. 101–608 designated existing provisions as par. (1) and added par. (2). 1981—Subsec. (a). Pub. L. 97–35 amended subsec. (a) generally, and in the requirements for consumer product safety standards, struck out reference to composition, contents, design, construction, finish, or packaging of consumer products, and struck out provision that the requirements of the standards other than requirements relating to labeling, warnings, or instructions, shall, whenever, feasible, be expressed in terms of performance requirements. Subsec. (b). Pub. L. 97–35 amended subsec. (b) generally, substituting provisions relating to the reliance by the Commission upon voluntary standards for provisions prescribing procedure for development of consumer product safety standards. Subsec. (c). Pub. L. 97–35 amended subsec. (c) generally, substituting provisions relating to contribution by the Commission to the development cost of consumer safety standards for provisions relating to publication of proposed safety rules developed from existing standards. Subsec. (d). Pub. L. 97–35 struck out subsec. (d) which related to the acceptance of offers to develop proposed standards and the Commission’s contribution to development costs. Subsec. (e). Pub. L. 97–35 struck out subsec. (e) which related to development of proposed safety rules by the Commission. Subsec. (f). Pub. L. 97–35 struck out subsec. (f) which provided for termination of rule-making proceedings and a statement relating to the reasons therefor. 1978—Subsec. (b). Pub. L. 95–631, §3, designated existing provision as par. (1), and in par. (1) as so redesignated, redesignated pars. (1) to (4) as subpars. (A) and (D), in subpar. (D) as so redesignated, inserted provision including as a means of commencing a proceeding, a publication in the Federal Register of a statement that the Commission intends to develop the proposed consumer product safety standard, added subpar. (E), struck out provision that the period specified within which the offeror of an accepted offer develops the proposed standard be a period ending 150 days after the date the offer was accepted unless the Commission for good cause found, and included such finding in the notice that a different period was appropriate, and added par. (2). Subsec. (c). Pub. L. 95–631, §5, amended subsec. (c) generally, inserting provisions relating to subsec. (b)(1)(D) and striking out provisions for publication of a proposed consumer product safety rule, in lieu of acceptance of an offer under subsec. (d), where a standard had been issued or adopted by any Federal agency or by any other qualified agency, organization, or institution and the standard if promulgated under the chapter would eliminate or reduce the unreasonable risk of injury associated with the product. Subsec. (d)(1). Pub. L. 95–631, §4(a)(1), inserted "subsection (b)(2) and by" after "as provided by" and substituted references to subsec. (b)(1)(D)(ii)(I) for (b)(4)(B) of this section and subsec. (b)(1)(E) for (b) of this section. Subsec. (d)(2). Pub. L. 95–631, §4(a)(2)(A)–(C), inserted in first sentence "or if any person participates with the Commission in the development of a consumer product safety standard under subsection (b)(2)(A) or subsection (e) of this section" after "under this subsection", "or the person’s cost with respect to such participation" after "safety standards" and "or person" after "offeror". Subsec. (d)(4). Pub. L. 95–631, §4(a)(3), added par. (4). Subsec. (e). Pub. L. 95–631, §(4)(b), amended provisions generally, and among other changes, substituted references to subsec. (b)(1)(D)(ii)(I) of this section for prior references to subsec. (b) of this section, and struck out par. (3) defining the development period, now covered in subsec. (b)(1)(E) of this section. Subsec. (f). Pub. L. 95–631, §4(c), amended provisions generally, and among other changes, reduced the period within which to publish a proposed consumer product safety standard to forty-five days from 150 days and required the publication in the Federal Register of the reasons for not publishing the proposed standard, including a statement indicative of the taking of other approaches such as a voluntary consumer safety standard adopted by persons to be subject to the proposed standard. 1976—Subsec. (a). Pub. L. 94–284, §6, designated existing provision as par. (1), redesignated as subpars. (A) and (B) existing pars. (1) and (2), and added par. (2). Subsec. (b). Pub. L. 94–284, §7(a), substituted "date the offer is accepted" for "publication of notice" in provision following par. (4)(B). Subsec. (d)(2). Pub. L. 94–284, §8(a), inserted provision which permits the Commission to advance public moneys without the need of authorized appropriations as required by section 529 of title 31. Subsec. (e). Pub. L. 94–284, §7(b), permitted the Commission to develop and publish a proposed consumer safety product rule if the development period as specified in par. (3) ends. Subsec. (f). Pub. L. 94–284, §7(c), provided that if within 60 days after publication of notice for a proceeding for the development of a consumer product safety standard (or longer if the Commission so prescribe), no offer is submitted or none is acceptable, the Commission terminate the proceeding or develop proposals of its own, which proposals be published as a rule within 150 days after the expiration of the 60 day period or the proceeding then terminated, and that if an offer is accepted within the 60 day period, then within 210 days after acceptance, the Commission must publish the proposal as a rule or terminate the proceeding.EFFECTIVE DATE OF 1981 AMENDMENT Amendment by Pub. L. 97–35 applicable with respect to regulations under this chapter and chapters 25 and 30 of this title for which notices of proposed rulemaking are issued after Aug. 14, 1981, see section 1215 of Pub. L. 97–35, set out as a note under section 2052 of this title.EFFECTIVE DATE Section effective on the sixtieth day following Oct. 27, 1972, see section 34 of Pub. L. 92–573, set out as a note under section 2051 of this title.CHILDREN’S GASOLINE BURN PREVENTION Pub. L. 110–278, July 17, 2008, 122 Stat. 2602, provided that: "SECTION 1. SHORT TITLE. "This Act may be cited as the ‘Children’s Gasoline Burn Prevention Act’. "SEC. 2. CHILD-RESISTANT PORTABLE GASOLINE CONTAINERS. "(a) Consumer Product Safety Rule.—The provision of subsection (b) shall be considered to be a consumer product safety rule issued by the Consumer Product Safety Commission under section 9 of the Consumer Product Safety Act (15 U.S.C. 2058). "(b) Requirements.—Effective 6 months after the date of enactment of this Act [July 17, 2008], each portable gasoline container manufactured on or after that date for sale in the United States shall conform to the child-resistance requirements for closures on portable gasoline containers specified in the standard ASTM F2517-05, issued by ASTM International. "(c) Definition.—As used in this Act, the term ‘portable gasoline container’ means any portable gasoline container intended for use by consumers. "(d) Revision of Rule.—If, after the enactment of this Act, ASTM International proposes to revise the child resistance requirements of ASTM F2517-05, ASTM International shall notify the Consumer Product Safety Commission of the proposed revision and the proposed revision shall be incorporated in the consumer product safety rule under subsection (a) unless, within 60 days of such notice, the Commission notifies ASTM International that the Commission has determined that such revision does not carry out the purposes of subsection (b). "(e) Implementing Regulations.—Section 553 of title 5, United States Code, shall apply with respect to the issuance of any regulations by the Consumer Product Safety Commission to implement the requirements of this section, and sections 7 and 9 of the Consumer Product Safety Act [15 U.S.C. 2056, 2058] shall not apply to such issuance. "(f) Report.—Not later than 2 years after the date of enactment of this Act [July 17, 2008], the Consumer Product Safety Commission shall transmit to the Committee on Energy and Commerce of the House of Representatives and the Committee on Commerce, Science, and Transportation of the Senate a report on— "(1) the degree of industry compliance with the standard promulgated under subsection (a); "(2) any enforcement actions brought by the Commission to enforce such standard; and "(3) incidents involving children interacting with portable gasoline containers (including both those that are and are not in compliance with the standard promulgated under subsection (a))." AUTOMATIC GARAGE DOOR OPENERS Pub. L. 101–608, title II, §203, Nov. 16, 1990, 104 Stat. 3123, provided that: "(a) Consumer Product Safety Rule.—The provisions of subsection (b) shall be considered to be a consumer product safety rule issued by the Consumer Product Safety Commission under section 9 of the Consumer Product Safety Act [15 U.S.C. 2058]. "(b) Requirements.— "(1) Effective on and after January 1, 1991, each automatic residential garage door opener manufactured on or after that date for sale in the United States shall conform to the entrapment protection requirements of the American National Standards Institute Underwriters Laboratories, Inc. Standards for Safety—UL 325, third edition, as revised May 4, 1988. "(2)(A) Effective on and after January 1, 1993, all residential automatic garage door openers manufactured on and after such date for sale in the United States shall conform to any additional entrapment protection requirements of the American National Standards Institute Underwriters Laboratories, Inc. Standards for Safety—UL 325, third edition, which were issued after the date of the enactment of this Act [Nov. 16, 1990] to become effective on or before January 1, 1993. "(B) If, by June 1, 1992, the Underwriters Laboratories, Inc., has not issued a revision to the May 4, 1988, Standards for Safety—UL 325, third edition, to require an entrapment protection feature or device in addition to that required by the May 4, 1988, Standard, the Consumer Product Safety Commission shall begin a rulemaking proceeding, to be completed no later than October 31, 1992, to require an additional such feature or device on all automatic residential garage door openers manufactured on or after January 1, 1993, for sale in the United States. If such a revision is issued by the Underwriters Laboratories, Inc. after the rulemaking has commenced, the rulemaking shall be terminated and the revision shall be incorporated in the consumer product safety rule under subsection (a) unless the Commission has determined under subsection (c) that such revision does not carry out the purposes of subsection (b). "(c) Revision of Rule.—If, after June 1, 1992, or the date of a revision described in subsection (b)(2)(B) if later, the Underwriters Laboratories, Inc. proposes to further revise the entrapment protection requirements of the American National Standards Institute Underwriters Laboratories, Inc. Standards for Safety—UL 325, third edition, the Laboratories shall notify the Consumer Product Safety Commission of the proposed revision and the proposed revision shall be incorporated in the consumer product safety rule under subsection (a) unless, within 30 days of such notice, the Commission notifies the Laboratories that the Commission has determined that such revision does not carry out the purposes of subsection (b). "(d) Labeling.—On and after January 1, 1991, a manufacturer selling or offering for sale in the United States an automatic residential garage door opener manufactured on or after January 1, 1991, shall clearly identify on any container of the system and on the system the month or week and year the system was manufactured and its conformance with the requirements of subsection (b). The display of the UL logo or listing mark, and compliance with the date marking requirements of UL 325, on both the container and the system, shall satisfy the requirements of this subsection. "(e) Notification.—Effective on and after July 1, 1991, all manufacturers of automatic residential garage door openers shall, in consultation with the Consumer Product Safety Commission, notify the public of the potential for entrapment by garage doors equipped with automatic garage door openers and advise the public to test their openers for the entrapment protection feature or device required by subsection (b). "(f) Preemption.—In applying section 26(a) of the Consumer Product Safety Act (15 U.S.C. 2075) [15 U.S.C. 2075(a)] with respect to the consumer product safety rule of the Consumer Product Safety Commission under subsection (a), only those provisions of laws of States or political subdivisions which relate to the labeling of automatic residential garage door openers and those provisions which do not provide at least the equivalent degree of protection from the risk of injury associated with automatic residential garage door openers as the consumer product safety rule provides shall be subject to such section. "(g) Regulations.—Section 553 of title 5, United States Code, shall apply with respect to the issuance of any regulations by the Consumer Product Safety Commission to implement the requirements of this section and sections 7 and 9 of the Consumer Product Safety Act [15 U.S.C. 2056, 2058] do not apply to such issuance. Any additional or revised requirement issued by the Commission shall provide an adequate degree of protection to the public. "(h) Construction.—Nothing in this section shall affect or modify in any way the obligations or liabilities of any person under the common law or any Federal or State law."
Citation
15 U.S.C. § 2056 (2018)